Changing the control board on a Harman Iron Accentra pellet stove

Yesterday, my wonderful wife had some unfortunate news for me: the Harman Iron Accentra pellet stove was on the fritz. For some reason, all of the lights started chaotically flickering on and off, not all together, but individually. Not only that, turning the pellet stove on lead to strange activity, as it would constantly turn on and off the various blower and feed motors, and failed to light the pellets. I had a feeling that the control board had finally given up.

Having had the pellet stove for several winters now, I really have grown to like it. Yes, it is not a perfect backup heat source, as it still requires electricity to run, but it is so much easier to use than a wood stove. For one, you have a tiny exhaust, rather than a big stack. You can set and forget a temperature, or just turn a dial to have it light a fire automatically. The unit itself is very aesthetically pleasing to look at, and the glass front makes for a great ambiance when the fire is lit.

I originally received this unit when I purchased a different pellet stove from a fellow church member who was leaving the state. Since I bought his other pellet stove, he offered me this broken one for free as well. Taking both home, I originally intended to use the other stove, but my wife fell in love with the look of this Accentra, and so I set about fixing it. It didn't take much to restore it to working order, though I did have to purchase two new sensors for it. I think one was an EDS (Exhaust Sensor) and a temperature sensor. After last winter, I did have to replace the heating unit, which gets hot and lights the pellets on fire, but overall, it's been a good unit.

Over time, though, I had suspected something might be wrong with the control board, as occasionally the Accentra would do something unexpected. Nothing dangerous, of course, but confusing. It would fail to light on multiple occasions, or when being turned off, it would crank in more pellets with the feed motor. So, months ago, I purchased a new control board, just in case. This was very fortunate, because when I came home to the "bad news" yesterday, I already had the part I figured I'd need to get it back to working order.

A picture of the old/removed board.

The first thing I did was to check the wiring and fuse to make sure it wasn't something else. Everything else seemed to be in order, so a simple operation began of removing two screws, popping off the various knobs, unhooking the connectors, and swapping the board. It was pretty quick overall. Start to finish took less than 30 minutes, though I spent a good deal of time testing the unit afterwards.

The only thing that was "odd" was that the new board fit several models. On the bottom of the board was a row of dip switches that you set for your particular model. For some reason, my model was not listed on the paperwork with pictures of dip switch settings. Fortunately, the old board also had this dip switch block, so I set the new board to match the old board, and drove on. The pattern was 00000001, if you need it for your board.

Either way, glory be to God, the unit worked right off the bat and we are back to having a cozy and warm living room!

Linux - keep it simple.

Electronics Harman Iron accentra

0 comment(s)

No comments yet. Be the first to comment.

Leave a comment

0 / 1000