Fix the stars, and then a snow plow...

Okay, not exactly fixing real stars, but rather fixing a little planetarium.

For school, one of my sons got a planetarium to look at the star formations, and it even has some slides with pictures of different planets that you place in a led/lamp style projector. Unfortunately, it arrived broken, but more unfortunate is that we didn't know it until a month later when we went to use it. By then it was past the point of return, so there was no hope of getting a replacement. Let's put it mildly that he was bummed.

Aside from a nasty rattle of some broken part rolling around inside, it didn't look damaged, but I ended up taking the entire assembly apart to get to the insides. Essentially it is a control board, a motor, and two LED lamps with lots of plastic around them.

It didn't take long to figure out the problem, as the broken part inside (which turned out to be a plastic post that broke off), had rattled around and tore off the wiring which went to the USB-C connector for power. About 30 seconds with the soldering iron and it was back to functional, and then I spent some 20 minutes figuring out how to overcome the broken plastic part. But, a spring and a screw and a little bit of luck provided a solution, and, for all intents and purposes, it works as good as new.

Next on the "needs fixed" to-do list was the plug in for my snow plow. You can't tell much from this picture, but the old connector for my snow plow had multiple pins that were busted, or wouldn't stay in place, or just didn't make good connections anymore. While this part is a straight plug, the other side is a 90 degree plug, and the wiring was pretty well beaten and torn. So, I replace the plugs with a 7 blade trailer lamp plug for all the controls, and a power plug that I took off of an old UPS battery backup system. It turned out rather nice, I think:

Of course, I still need to mount them in some fashion. I was thinking of making a custom plate that they mount to, which is then bolted to the plow mount itself, but we'll see. Either way, it was a huge blessing that the wiring worked the first time I used it, and I feel like the plow moved better than it ever had before!

Linux - keep it simple.

Electronics planetarium solder snow plow plow

Fixing USB game controllers

Not much to say in this post, just taking some time for some soldering practice while I fix a couple broken USB controllers.

I got these cheap USB video game controllers that I've been using with a Retro Game Stick, you know, the little stick that you plug into your TV HDMI port that comes with thousands of games? I have some posts about hacking mine, and feel free to check those posts out. [1] But back to the subject at hand, these USB controllers worked pretty good, but after a year of use (only on Saturdays), both of these controllers quit working. As you can see from the picture below, the stress on the cable at the gromet caused the wires to break.

 

That left me with two choices, throw them out or fix them. So I decided to fix them. I had to cut the gromet down one side so I could slip it back over the wire when I was done, and I put some heat shrink around that to hold it together tightly. A little loop of wire inside to prevent the kids from pulling it out, resolder the connections, put a little paint over the wires where they were soldered, and I'm all done!

It even worked when I tested it!

Linux - keep it simple.

[1] https://alaskalinuxuser3.ddns.net/tag/nostolgia-stick-game.html

Electronics Nostolgia Stick Game Retro Game Stick USB controller solder